Search
导航菜单
文章正文
Plastic pellet mill operating problems (plastic granulator machinery suggest you )
Published:2015-01-04 11:24:57    Text Size:【BIG】【MEDIUM】【SMALL
Summary:Pay attention to the plastic particles body temperature changes, touch left the note with clean hands, immediately warming. Until it left the note as normal. Reducer bearing parts when burned hand, or with the noise should be timely maintenance, and added fuel. Host bearing chamber at both ends of the bearing parts hot burning hands or murmur to downtime and butter filling. When working properly, the bearing chamber butter once every 5-6 days. When the body is unstable operation, you should be careful to check whether the coupling gap tight fit, to loosen some timely.

Plastic pellet mill operating problems (plastic granulator machinery suggest you )

Pay attention to the plastic particles body temperature changes, touch left the note with clean hands, immediately warming. Until it left the note as normal. Reducer bearing parts when burned hand, or with the noise should be timely maintenance, and added fuel. Host bearing chamber at both ends of the bearing parts hot burning hands or murmur to downtime and butter filling. When working properly, the bearing chamber butter once every 5-6 days. When the body is unstable operation, you should be careful to check whether the coupling gap tight fit, to loosen some timely.
Control effect plastic pellet mill barrel and expectations are not always the same, especially in the measurement area? If the barrel is heated, the viscosity of the material layer at the cylinder wall becomes small, the energy from the motor in a smoother running cartridge needs less. Motor current (amperage) decreased. Conversely, if the barrel cooling, the melt viscosity of the cylinder wall increases, the motor must rotate more forcefully, increasing the amperage, by removing some of the heat of the barrel when they were returned to the motor. Typically, the barrel adjuster does have an effect on the melt, which is what we expect, but the effect of any local variables are not large area. The best is to measure the melt temperature to really understand what happened.

Download the attachment: (Has been downloaded 0 times)
Category
Search